hvbatt_a737_bp2cacimbalancelimp
Drive with cautionTesla · HVBATT system
High-Voltage Battery — Capacity Imbalance Triggering Limp Mode (Section 2)
What it means
The capacity spread inside the second pack section has pushed the BMS into limp mode. Acceleration and charging are deliberately restricted, and maximum range drops, all to keep the weakest cell groups from being damaged further.
Symptoms
- "High-voltage battery needs service" message
- "Acceleration and charging performance reduced" warning
- Reduced acceleration and charging speed
- Significantly reduced maximum range
Likely causes (by probability)
- 1.Failing cell group(s) inside the second pack sectionHigh
- 2.Progressing internal cell shortMedium
- 3.Measurement fault (unlikely once limp mode triggers)Low
What you can check yourself
- 01Drive gently and avoid deep discharges or repeated fast charging until service
- 02Record range, charge speed, and when the alert set for the service visit
- 03Check companion alerts (a735, w723) for the full imbalance picture
- 04Leave the pack alone — limp mode means internal cell problems that only Tesla Service can address
EV systems involved in hvbatt_a737_bp2cacimbalancelimp
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Drive unit (motor + inverter)
The inverter switches battery DC into the variable AC that spins the motor, and the resolver (position sensor) tells it exactly where the rotor is. Torque control is only as good as that position feedback and the inverter's thermal headroom.
Severity
Still drivable, but baby it. Schedule battery service promptly — this level of imbalance typically means pack repair, and warranty coverage matters a lot here.
Estimated repair cost
Dealer / service center
— – —
Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- hvbatt_a237_bmsassertedcpfaultlineHigh-Voltage Battery — BMS Declared a Charge Port Fault (Welded Contactor)
- hvbatt_a281_acjbbedl3relaymaybeweldedHigh-Voltage Battery — Bed Outlet Line 3 Relay Suspected Welded (ACJB)
- hvbatt_a123_isolationfailureindrivewarningHigh-Voltage Battery — Repeated Isolation Faults Across Drives
- hvbatt_a278_acjbcplinerelaymaybeweldedHigh-Voltage Battery — Charge Port Line Relay Suspected Welded (ACJB)