All codes

hvbatt_a278_acjbcplinerelaymaybewelded

Drive with caution

Tesla · HVBATT system

High-Voltage Battery — Charge Port Line Relay Suspected Welded (ACJB)

What it means

The BMS suspects — but has not fully confirmed — that the charge port line relay in the AC junction box is welded. It responds the same way as the confirmed fault: outlets and DC charging go offline while AC charging still works. Sometimes this is the early stage of the confirmed a248 alert.

Symptoms

  • No customer-facing message in many cases
  • Power outlets may be disabled (Cybertruck)
  • DC fast charging may be unavailable
  • AC charging continues to work

Likely causes (by probability)

  1. 1.Charge port line relay beginning to weld or sticking intermittentlyMedium
  2. 2.Marginal relay sensing circuit giving ambiguous readingsMedium
  3. 3.Prior stress on the outlet/charging circuitLow

What you can check yourself

  • 01Test AC charging to confirm you still have a way to charge
  • 02Watch for escalation to the confirmed welded alert (a248)
  • 03Note any recent heavy outlet use or charging faults
  • 04Schedule service — suspected welded relays are internal high-voltage hardware

EV systems involved in hvbatt_a278_acjbcplinerelaymaybewelded

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Vehicle network (CAN / gateway)

Multiple CAN buses link every controller; the gateway routes messages between them and to diagnostics. "MIA" (missing in action) alerts almost always mean a node stopped sending on its bus — the cause can be the node itself, its wiring, or its power supply.

Severity

Drive with caution

Keep using AC charging and avoid relying on outlets or DC fast charging. Book service before it graduates to a confirmed welded relay.

Estimated repair cost

Dealer / service center

— – —

Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site