hvbatt_a742_vshfailure
Do not driveTesla · HVBATT system
High-Voltage Battery — Voltage Sense Harness Failure
What it means
The BMS measures each cell group through a delicate sense harness (VSH), and it has detected abnormally high resistance in that harness — a broken wire, corroded contact, or failing connector inside the pack. The car treats this as a serious fault because without trustworthy cell voltages it cannot safely manage the battery, and it may block driving and charging.
Symptoms
- "Vehicle may not restart — Service required" message
- Charging, driving, or low-voltage support may be unavailable
- Warning chime when the alert sets
- May appear suddenly without prior symptoms
Likely causes (by probability)
- 1.Broken or corroded connection in the internal voltage sense harnessHigh
- 2.Failing battery monitoring board (BMB) connectorMedium
- 3.Physical pack damage (impact, improper lifting)Low
What you can check yourself
- 01Note any recent underbody impacts or service work near the pack
- 02Check for the related open-circuit alert (BMS_w177) which narrows down the fault
- 03Do not keep cycling the car hoping it clears — high impedance in the sense harness is a hardware fault
- 04Absolutely no DIY here: the sense harness is inside the sealed, high-voltage battery pack
EV systems involved in hvbatt_a742_vshfailure
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Low-voltage (12V/16V) system
The small battery and DC-DC converter that power every computer, relay, contactor coil and sensor in the car. EVs are famously sensitive to a weak low-voltage battery — it causes cascading "ghost" faults across unrelated systems.
Severity
This can strand the car without warning. Schedule service immediately and minimize driving — if the car will not restart, request a tow.
Estimated repair cost
Dealer / service center
— – —
Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- hvbatt_a722_bp1dsoclimitingHigh-Voltage Battery — Charging Capped at ~50% Because of a Weak Cell Group
- hvbatt_a237_bmsassertedcpfaultlineHigh-Voltage Battery — BMS Declared a Charge Port Fault (Welded Contactor)
- hvbatt_a281_acjbbedl3relaymaybeweldedHigh-Voltage Battery — Bed Outlet Line 3 Relay Suspected Welded (ACJB)
- hvbatt_a737_bp2cacimbalancelimpHigh-Voltage Battery — Capacity Imbalance Triggering Limp Mode (Section 2)