All codes

bms_f152_sw_pos_contactor_welded

Do not drive

Tesla · BMS system

Battery Management System: Positive Contactor Welded

What it means

The BMS determined the positive main contactor is welded shut — its contacts fused together, usually from arcing during an under-load opening event. A welded contactor cannot disconnect the pack when it should, which is a serious safety state. This alert must be manually cleared by service after repair.

Symptoms

  • Driving, charging, and low-voltage support disabled
  • Car may fail to power down high-voltage systems correctly
  • No customer text in many cases — found in service mode

Likely causes (by probability)

  1. 1.Contactor contacts fused by arcing during under-load switchingHigh
  2. 2.Contactor at end of life after many high-stress cyclesMedium
  3. 3.False weld detection from a sensing faultLow

What you can check yourself

  • 01Do not attempt repeated restarts — a welded contactor is a hardware failure, not a glitch
  • 02Check for the event that caused it: companion alerts like bms_f024 (opened under load) tell the story
  • 03Check for bms_f030 as well — a welded fast-charge contactor often appears together
  • 04Contactor replacement is pack-internal work with lethal voltages — absolutely no DIY

EV systems involved in bms_f152_sw_pos_contactor_welded

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

High-voltage distribution & safety

Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.

Severity

Do not drive

Not drivable. A welded contactor means the pack cannot safely disconnect — tow to Tesla Service for contactor replacement.

Estimated repair cost

Dealer / service center

— – —

Contactor replacement is covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site