bms_f006_hw_ctr_sfty_override
Do not driveTesla · BMS system
Battery Management System — Contactor Safety Override Detected
What it means
The BMS detected unexpected voltage on the contactor service-bypass pin — a line that should only ever be active under controlled service conditions. An active bypass at the wrong time suggests tampering, a wiring fault, or failed control hardware, and it defeats the pack's ability to disconnect safely. The car blocks driving, charging, and low-voltage support.
Symptoms
- "Service required — Schedule service immediately" message
- Car cannot drive or charge
- Single chime with a warning icon
- May follow previous high-voltage service work
Likely causes (by probability)
- 1.Service bypass tool or jumper left connected after prior workMedium
- 2.Wiring short putting voltage on the bypass pinMedium
- 3.Failed contactor control hardwareLow
- 4.Unauthorized tampering with the high-voltage systemLow
What you can check yourself
- 01Recall any recent service or third-party work on the high-voltage system and report it in detail.
- 02Do not attempt to locate or remove a bypass yourself — it sits in the high-voltage path.
- 03Arrange a tow; this alert is designed to keep the car parked.
- 04If you bought the car used and it has salvage history, tell service — prior pack repairs are a common source.
EV systems involved in bms_f006_hw_ctr_sfty_override
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
High-voltage distribution & safety
Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.
Severity
Straight to service. A defeated safety interlock is not something to drive on or troubleshoot in a driveway.
Estimated repair cost
Dealer / service center
— – —
Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_a107_sw_stack_voltage_miaBattery Management System — Stack Voltage Measurement Lost
- bms_f086_sw_not_ok_to_prechargeBattery Management System: Not OK to Precharge
- bms_f173_sw_brick6_senseBattery Management System: Brick 6 Voltage Sense Inconsistency
- bms_w033_sw_crashBattery Management System — Crash Detected (Battery Pyrofuse Blown)