bms_w080_sw_int_hv_disconnect
Do not driveTesla · BMS system
Battery Management System — Internal High-Voltage Disconnect Detected
What it means
The BMS compared the pack's total voltage against the sum of all cell-group voltages and found a significant difference — strong evidence that something inside the pack's high-voltage path is disconnected or dropping voltage. The car won't charge or drive, and the pack can't support the 12V system. This points at an internal connection fault, not a cell problem.
Symptoms
- Car won't drive or charge
- Car may not restart
- "Service needed" warning
- May appear after pack-related service or an impact
Likely causes (by probability)
- 1.An internal high-voltage connection inside the pack left loose or disconnected (often after service)High
- 2.A failed internal busbar, link, or connector inside the packMedium
- 3.Voltage-sense wiring fault giving a false mismatchLow
What you can check yourself
- 01Note any recent battery service, salvage history, or impacts.
- 02Photograph the alert list for the service visit.
- 03Do not attempt any inspection involving the battery case — sealed high-voltage hardware; Tesla Service only.
- 04Arrange a tow rather than repeated start attempts.
EV systems involved in bms_w080_sw_int_hv_disconnect
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Low-voltage (12V/16V) system
The small battery and DC-DC converter that power every computer, relay, contactor coil and sensor in the car. EVs are famously sensitive to a weak low-voltage battery — it causes cascading "ghost" faults across unrelated systems.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
Severity
An internal disconnect means the pack can't safely deliver power. Tow to Tesla Service and mention any recent pack work.
Estimated repair cost
Dealer / service center
— – —
Covered under battery warranty in many cases; if it followed third-party service, that shop should be involved. Out-of-warranty cost varies — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_f096_sw_fast_charger_miaBattery Management System: Fast Charger Communication Lost
- bms_u002_ramp_down_activeBattery Management System: Battery Ramp-Down Active
- bms_w037_sw_pos_contactorBattery Management System — Positive Contactor Stuck or Welded
- bms_w142_sw_isolation_degradatioBattery Management System — High-Voltage Isolation Degraded (Warning Level)